Table of Contents
Advertisement
Tiger Explorer XR Series
5.
Thoroughly clean the seal housing.
Flywheel, Starter Drive Gears and Sprag Clutch - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
1.
Protect the front cover mating face of the bevel box against damage and place it in a press.
2.
Using the collar from T3880053 - Wheel Bearing Extraction Kit (smaller diameter positioned on the outer
edge of the seal), carefully press in a new oil seal.
Failure to protect the splines of the damper shaft will result in damage to the new oil seal.
3.
Protect the splines and the groove (as shown below) of the damper shaft with a suitable tape, such as
electrical insulation tape. Do not apply tape to the seal running area, shown grey below.
197 of 746
1.
Oil seal
WARNING
1
chil
1.
Bevel box
2.
Collar (part of T3880053 - Wheel Bearing Extraction
Kit)
CAUTION
2
1
2
TRANSMISSION
Hide quick links:
Advertisement
Chapters
Table of Contents
