Triumph Tiger Explorer XR 2017 Service Manual page 350

Tiger Explorer XR Series
5. Secure the canister in place with the cable tie and trim off any excess cable tie.
Refit the rear suspension unit (see Rear Suspension Unit - Installation).
Refit the exhaust silencer (see Exhaust System - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Purge Control Valve - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the fuel tank (see Fuel Tank - Removal).
Disconnect the swinging arm position sensor push rod from the swinging arm and position aside.
Note
The electrical connector for the purge control valve is located above the crankcase tidy. Note the
position of the electrical connector for installation.
The main harness for the purge valve electrical connector is looped over the hook at the top of the
crankcase tidy. Note the routing of the main harness for the purge valve electrical connector, and the
purge valve fly lead for installation.
1. Carefully unhook the main harness for the purge valve electrical connector from the crankcase tidy.
346 of 746
2
chjk
1. Canister
2. Cable tie
3. Fixing
WARNING
2
1. Crankcase tidy
2. Main harness to purge valve electrical connector
1
FUEL SYSTEM / ENGINE MANAGEMENT