Table of Contents
Advertisement
Tiger Explorer XR Series
Note
Upon clicking START, the diagnostic tool will send a command to the chassis ECM to perform an
RSU preload motor calibration the next time the ignition is switched On.
4.
Click start, then disconnect the Triumph Diagnostic Tool from the motorcycle.
5.
Turn the ignition switch Off and allow the chassis ECM to power down. This should take approximately 10
seconds.
6.
Turn the ignition switch On. The RSU preload motor calibration will start automatically. Do not start the
engine at this stage.
Note
The motorcycle must remain stationary during calibration. If the motorcycle is moved or ridden, this
will halt the calibration and cause the TSAS warning light to become illuminated. In this situation,
calibration will be restarted the next time the ignition switch is turned Off then On again.
During calibration, the TSAS warning light will flash and the message WARNING - TSAS SYSTEM
FAULT will be displayed in the instrument's multifunction display.
This warning message can be cleared by pressing the SELECT button on the left handlebar switch
housing.
Upon clearing the warning message, the information message TSAS SYSTEM CALIBRATING -
PLEASE WAIT will be displayed.
Calibration is complete when the instrument messages clear and the TSAS warning light stops
flashing.
7.
Wait for the TSAS warning light to stop flashing, indicating that the RSU preload motor calibration is
complete.
Never start the engine or let it run for any length of time in a closed area. The exhaust fumes are poisonous
and may cause loss of consciousness and death within a short time. Always operate the motorcycle in the
open-air or in an area with adequate ventilation.
8.
Start the engine and check that the TSAS warning light remains off. If the warning light resumes flashing, the
RSU preload motor is being recalibrated due to low battery voltage. Wait for the warning light to stop flashing
before turning the engine off.
9.
When the calibration has successfully completed, reconnect the Triumph Diagnostic Tool and check for any
stored DTCs. Rectify as necessary.
418 of 746
3
1.
Instrument message
2.
TSAS warning light
3.
SELECT button
WARNING
OFF-ROAD
W ARNING
T SAS
SY ST E M F AUL T
C HE C K MANUAL
PRE SS SE L EC T
T O C L EAR
1
2
REAR SUSPENSION
Hide quick links:
Advertisement
Chapters
Table of Contents
