Triumph Tiger Explorer XR 2017 Service Manual page 583

Tiger Explorer XR Series
2. Repeat step 1 for the other infill panel.
3. Connect the electrical connector to the auxiliary socket on the front panel.
4. Position the front panel onto the fuel tank, ensuring that its locating lug fits into its bracket on the fuel tank.
5. Fit the fixings for the front panel and tighten them to 3 Nm.
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Side Fairings - Installation
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the fuel tank infill panels (see Fuel Tank Infill Panels - Removal).
1. Protect the side fairings from damage by applying masking tape to the area shown below.
579 of 746
2
1. Fuel tank infill panel (right hand shown)
2. Fixings
1
chpg_1
1. Locating lug
2. Bracket
WARNING
2
FRAME / BODYWORK