Triumph Tiger Explorer XR 2017 Service Manual page 597

Tiger Explorer XR Series
Note
Note that the radiator mounting bracket is positioned between the engine bar and the engine for
installation.
10. Release the upper mounting bolt and remove the right hand engine bar and link bar assembly.
Pannier Mounting Frames - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
During installation of the right hand engine bar it is necessary to loosen various engine to frame and rear
suspension mounting fixings. The engine to frame alignment must then be reset using T3880637 - Kit,
Engine to Frame Alignment Bars and the mounting fixings re-tightened in a specific sequence. Failure to
follow these instructions precisely will affect handling, stability and other aspects of the motorcycle's
operation which may result in loss of motorcycle control and an accident.
Remove the side fairings (see Side Fairings - Removal).
Remove the sump guard (see Sump Guard - Removal).
1. Raise and securely support the motorcycle.
2. Place a support beneath the engine and ensure the frame is adequately and securely supported.
593 of 746
1. Lower crankcase mounting bolt
2. Centre mounting bolt
3. Spacer, 13 mm
1
2
1. Radiator mounting bracket
2. Upper mounting bolt
WARNING
Right Hand Engine Bar
WARNING
FRAME / BODYWORK