Triumph Tiger Explorer XR 2017 Service Manual page 280

Tiger Explorer XR Series
Test
3 Check cable continuity:
- Engine ECM pin B42 to sensor pin 1
- Ground to sensor pin 2
4 Check cable for short circuit:
- Engine ECM pin B42 to ground
5 Check sensor resistance:
- sensor pin 1 to sensor pin
2(temperature dependent - see circuit
diagram resistance data)
6 Reconnect harness, clear fault code
and run engine to verify fault cleared
Circuit Diagram
If engine is warm, remove sensor and allow time to cool to ambient prior to test.
Resistance data:
Ambient temp Resistance value
80°C 200 to 400 Ohms
20°C 2.35 to 2.65 K Ohms
-10°C 8.50 to 10.25 K Ohms
Fault Code
P0560
276 of 746
Result
OK
Open circuit
OK
Short circuit
OK
Faulty
OK
Fault still present
Possible Cause
System Voltage - battery circuit
malfunction
Action
Proceed to test 5
Locate and rectify wiring fault, proceed
to test 6
Proceed to test 5
Locate and rectify wiring fault, proceed
to test 6
Proceed to test 6
Renew air temperature sensor and
proceed to test 6
Action complete - quit test
Contact Triumph service
Action
View and note diagnostic tool
'sensor' data
Ensure Voltage across battery is
acceptable, note Voltage
Disconnect Engine ECM and
proceed to pinpoint test 1:
FUEL SYSTEM / ENGINE MANAGEMENT