Triumph Tiger Explorer XR 2017 Service Manual page 721

Tiger Explorer XR Series
Refit the high level mudguard (see High Level Mudguard - Installation).
Refit the cockpit panels (see Cockpit Panels - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Direction Indicators - Bulb Replacement
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Note
The rear light is a sealed for life unit and must be replaced in the event of a failure.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the rear mudguard (see Rear Mudguard - Removal).
Note
Note the routing of the seat lock cable for installation.
1. Release the three fixings shown below and remove the rear light and bracket assembly.
717 of 746
2
cjle
1. Fixings (left hand shown)
2. Washers
WARNING
3
1
chlz_4
1
1
2
1
ELECTRICAL