Triumph Tiger Explorer XR 2017 Service Manual page 588

Tiger Explorer XR Series
Refit the fuel tank infill panels (see Fuel Tank Infill Panels - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Seat Infill Panel - Installation
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the side fairings (see Side Fairings - Removal).
1. Release the fixing securing the rear of the seat infill panel to the frame. Remove the flanged sleeve.
2. Carefully pull the front of the infill panel away from the fuel tank to release its front locating lug from its
rubber grommet on the fuel tank.
3. Slide the infill panel rearwards to release the centre locating lug from its mounting screw on the fuel tank and
remove the panel.
584 of 746
WARNING
3
chpv
1. Flanged sleeve
2. Fixing
3. Seat infill panel (left hand shown)
2
1
3
choy
2
1
4
5
FRAME / BODYWORK