Triumph Tiger Explorer XR 2017 Service Manual page 520

Tiger Explorer XR Series
Note
ABS manoeuvre means that the ABS system is in its active state and is controlling brake pressure to
prevent the wheel(s) from slipping (skidding).
Once ABS operation has been inhibited, the ABS ECM will act in one of three ways:
1. Allow the ABS to resume operation immediately if the fault clears.
2. Allow the ABS to resume operation after an ignition cycle if the fault clears.
3. Inhibit the ABS function until the fault is rectified and the DTC erased.
The ABS system will act on the DTC stored according to the table:
Note
When vehicle speed has exceeded 6 mph (10 km/h) and the flashing ABS warning light has been
extinguished, the ABS has initialised.
Fault code and
description
Front wheel sensor short
circuit to ground or open
circuit
Front wheel sensor short
circuit to ground or open
circuit
Front wheel sensor
incorrect or missing signal
Front wheel sensor
incorrect or missing signal
Rear wheel sensor short
circuit to ground or open
circuit
Rear wheel sensor short
circuit to ground or open
circuit
Rear wheel sensor
incorrect or missing signal
Rear wheel sensor
incorrect or missing signal
Front wheel pulser ring
missing teeth
516 of 746
ABS ABS operation is
warning inhibited
light immediately when
Illuminated fault is logged
when fault is
logged
Yes Yes
Yes
Yes Yes
Yes
Yes
ABS ABS will automatically
continues to resume operation if
operate if fault clears(DTC still
performing an stored for 40 cycles)
ABS
manouevre
when fault is
logged
Operation is
inhibited when
ABS
manouevre is
completed
No
DTC stored for 40
cycles.
Yes Yes, if after ignition
cycle, no fault is
detected and ABS has
initialised.
DTC stored for 40
cycles.
No
DTC stored for 40
cycles.
Yes Yes, if after ignition
cycle, no fault is
detected and ABS has
initialised.
DTC stored for 40
cycles.
Yes Yes, if after ignition
cycle, no fault is
BRAKES