Triumph Tiger Explorer XR 2017 Service Manual page 265

Tiger Explorer XR Series
2. Refit the engine ECM (see Engine Electronic Control Module (ECM) - Installation).
Further Diagnosis
The tables that follow will, if used correctly, help to pinpoint a fault in the system once a diagnostic trouble code
has been stored.
Crankshaft Sensor
Fault Code
P0335
Pinpoint Tests
Test
1 Check terminal and cable integrity:
- Engine ECM pin A35
- Engine ECM pin A36
2 Check cable for short circuit:
- Engine ECM pin A35 to ground
- Engine ECM pin A36 to ground
3 Check cable continuity:
- Engine ECM pin A35 to sensor pin 1
- Engine ECM pin A36 to sensor pin 2
4 Check cable for short circuit:
- Engine ECM pin A35 to Engine ECM
pin A36
5 Check crank toothed wheel:
- Damage to teeth - magnetic debris
contamination
6 Reconnect harness, clear fault code
261 of 746
1. Connector B (large)
2. Connector A (small)
Possible Cause
Crankshaft sensor circuit
malfunction
Result
OK
Faulty
OK
Short circuit
OK
Open circuit
OK
Short circuit
OK
Faulty
OK
Action
View and note diagnostic tool
'freeze frame' data if available
Ensure sensor is fitted correctly
and connector is secure
Disconnect Engine ECM and
proceed to pinpoint test 1:
Action
Disconnect crankshaft sensor and
proceed to test 2
Rectify fault, proceed to test 6
Proceed to test 3
Locate and rectify wiring fault, proceed
to test 6
Proceed to test 4
Locate and rectify wiring fault, proceed
to test 6
Renew crankshaft sensor, proceed to
test 5
Locate and rectify wiring fault, proceed
to test 6
Proceed to test 6
Clean/renew toothed wheel, proceed to
test 6
Action complete - quit test
FUEL SYSTEM / ENGINE MANAGEMENT