Triumph Tiger Explorer XR 2017 Service Manual page 620

Tiger Explorer XR Series
Fit the pannier rails (see Pannier Rails - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Battery Tray - Installation
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Remove the battery (see Battery Removal).
Remove the fuel tank (see Fuel Tank - Removal).
Remove the chassis ECM (see Chassis Electronic Control Module (ECM) - Removal).
Remove the engine ECM (see Engine Electronic Control Module (ECM) - Removal).
Remove the rear mudguard (see Rear Mudguard - Removal).
Remove the rear wheel (see Rear Wheel - Removal).
Note
Note the routing of the rear section of the harness and the positions of its electrical connections
prior to removal.
1. Disconnect the following:
Alarm electrical connector
Heated seats sub harness to main harness electrical connectors (if fitted)
Front heated seat switch electrical connector (if fitted)
Rear wheel speed sensor electrical connector.
2. Detach the following from the battery tray:
Powered top box electrical connector
USB socket
Heated seats main harness electrical connectors
ABS fuse box
Main fuse box.
3. Remove the fixing securing the ambient air pressure sensor to the battery tray.
616 of 746
WARNING
1
cjib
1. Ambient air pressure sensor
2. Fixing
3
2
FRAME / BODYWORK