Table of Contents
Advertisement
Tiger Explorer XR Series
2.
Position a container to collect the displaced coolant.
3.
Remove the drain screw located on the left hand side of the radiator and allow the coolant to drain.
4.
To drain the crankcase, remove the drain screw shown in the illustration below. Discard the washer.
Note
It is not possible to completely drain all of the coolant, a small amount may remain in the water
pump or heat exchanger.
Filling
Filling the cooling system with the motorcycle positioned on the centre stand will cause an airlock, reducing
the cooling system efficiency
Always place the motorcycle on the side stand when filling the cooling system.
Reduced cooling system efficiency may cause the engine to overheat and suffer severe damage.
1.
Refit the radiator drain screw and tighten to 1.5 Nm.
355 of 746
1
1.
Coolant pressure cap
2
1.
Crankcase coolant drain screw
2.
Radiator coolant drain screw
CAUTION
1
COOLING
Hide quick links:
Advertisement
Chapters
Table of Contents
