Table of Contents
Advertisement
Tiger Explorer XR Series
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
1.
Raise and support the motorcycle.
Wear hand, eye and face protection when unhooking the stand spring. Take great care to minimise the risk of
personal injury and loss of components.
2.
With the side stand in the up position, unhook the spring from the side stand and remove it from the
motorcycle.
3.
Remove and discard the E-clip securing the pivot pin.
4.
Remove the pivot pin and remove the side stand.
Side Stand - Installation
1.
Smear the upper and lower contact surfaces of the side stand and side stand carrier bracket with Castrol
High Temperature Grease.
Note
The side stand leg pivot holes may be fitted with dry lubrication bushes on some later models.
Where this is the case, it is not necessary to lubricate the shank of the side stand pivot pin.
2.
Check if bushes are fitted to the side stand leg pivot holes. If no bushes are fitted, smear the shank of the
side stand pivot pin with Castrol High Temperature Grease.
621 of 746
WARNING
WARNING
3
4
2
1.
Side stand
2.
Spring
3.
Pivot pin
4.
E-clip
3
1
1
4
FRAME / BODYWORK
Hide quick links:
Advertisement
Chapters
Table of Contents
