Table of Contents
Advertisement
Tiger Explorer XR Series
4.
Remove T3880602 - Alternator Wrench and fully remove the nut. Discard the nut.
5.
Remove the decoupler and drive gear assembly from the alternator spline.
6.
Release the fixings and remove the drive gear from the decoupler.
Assembly is the reverse of Alternator - Disassembly, noting the following:
Note
Tighten the drive gear to decoupler fixings to 3 Nm.
Always fit a new nut when refitting the decoupler and drive gear assembly.
Tighten the decoupler and drive gear assembly nut to 54 Nm.
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
1.
Fit a new O-ring to the alternator body.
2.
Refit the alternator to the crankcase and align the three fixing holes. Fit and tighten the fixings to 28 Nm.
728 of 746
1.
Alternator decoupler
2.
T3880602 - Alternator Wrench
3.
8 mm Allen key
1
1.
Drive gear
2.
De-coupler
3.
Fixings
WARNING
1
3
2
ELECTRICAL
Hide quick links:
Advertisement
Chapters
Table of Contents
