Triumph Tiger Explorer XR 2017 Service Manual page 347

Tiger Explorer XR Series
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
1. Fit the reed valves to the camshaft cover as noted for removal.
2. Refit the valve covers and the connector bracket as noted for removal. Tighten the fixings to 9 Nm.
3. Refit the air hoses to the reed valves as noted for removal.
Refit the airbox (see Airbox - Installation).
Refit the fuel tank (see Fuel Tank - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Evaporative Canister - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the exhaust silencer (see Exhaust System - Removal).
Remove the rear suspension unit (see Rear Suspension Unit - Removal).
Note
Note the routing of the cable tie for installation.
1. Cut the cable tie securing the canister to its bracket.
2. Remove the fixing from the right hand side of the canister.
343 of 746
WARNING
1
1. Spring-close clip
2. Secondary air injection hose
3. Reed valve assembly
WARNING
3
2
FUEL SYSTEM / ENGINE MANAGEMENT