Triumph Tiger Explorer XR 2017 Service Manual page 502

Tiger Explorer XR Series
Do not install shims. If the specified air gap cannot be achieved, investigate and rectify the cause before
proceeding.
3. If the rear wheel speed sensor has been removed, install a new fixing and tighten to 9 Nm.
4. Re-check the air gap measurement.
5. For specifications refer toBrakes.
Rear ABS Wheel Speed Sensor - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Remove the battery (see Battery Removal).
1. Disconnect the wheel speed sensor multiplug, identified as the white connector, located in the left hand side
of the battery tray, under the seat bridge.
2. Remove the three fixings and remove the expansion tank cover. Discard the upper M5 fixing. Retain the
lower M6 fixings for reuse.
498 of 746
1. ABS sensor
2. Pulser ring
3. Bevel box
CAUTION
WARNING
1
cjjo
1. Wheel speed sensor multiplug
2
1
BRAKES