Triumph Tiger Explorer XR 2017 Service Manual page 725

Tiger Explorer XR Series
Note
Ensure that the drain hole in the indicator lens is at the bottom.
1. Position the direction indicator to the cockpit subframe and secure with the fixing. Tighten the fixing to 5 Nm.
2. Route the direction indicator harness as noted during removal and secure into the clips on the cockpit
subframe.
Note
The main harness for the right hand direction indicator is marked with red tape to aid correct
connection.
3. Connect the direction indicator to the main harness.
Refit the headlight assembly (see Headlight Assembly - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Check the operation of the direction indicators, rectify as necessary.
Starting Circuit
Diagnosis – Starter Circuit
Alternator
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the rear mudguard (see Rear Mudguard - Removal).
1. Release the fixings securing direction indicators to the rear mudguard.
721 of 746
2
cjlt
1. Direction indicator (right hand shown)
2. Fixing
WARNING
1
1
1
ELECTRICAL