Table of Contents
Advertisement
Tiger Explorer XR Series
Note
Make sure the engine is still adequately supported.
6.
Remove and discard the lock nuts from the front cylinder head bolts.
7.
Loosen the rear cylinder head bolts. Do not fully remove.
8.
Remove the upper crankcase mounting bolt, washer and lock nut. Discard the lock nut.
9.
Remove the bolt and washer from the right hand front cylinder head mounting.
Note
There are three frame adjuster sleeves for this model. They are located as follows:
Two of the frame adjuster sleeves are located on the right hand side of the frame.
The third frame adjuster sleeve is located in the front right hand mounting of the cylinder head.
10.
Using T3880377 - Engine Mounting Adjuster, loosen the frame adjuster sleeves.
595 of 746
4
5
3
6
1.
Left hand front cylinder head bolt
2.
Left hand rear cylinder head bolt
3.
Right hand front cylinder head bolt
4.
Right hand rear cylinder head bolt
5.
Upper crankcase bolt
6.
Lower crankcase bolt
2
1
FRAME / BODYWORK
Hide quick links:
Advertisement
Chapters
Table of Contents
