Remove The Cold Mirror - Christie Solaria One Service Manual

3.32.3 Remove the Cold Mirror

UV HAZARD! Always wear protective safety clothing and a face shield when perform-
ing service with the safety shield removed and a lamp installed.
NOTICE: Wear gloves when you handle the cold mirror.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lamp. See
4. Remove the side projector skin. See
5. Remove the 4 cold mirror heat sink plate screws and then remove the heat sink (A).
6. Remove the top 2 hex screws and clips holding the cold mirror.
7. Loosen the bottom 2 hex screws holding the cold mirror.
8. Grasp the top corners of the mirror, and then pull it up and out. When reinstalling the cold mirror, make
sure that the reflective surface faces inwards. Also, you must recalibrate MCGD. See the Solaria One or
Solaria One+ user manuals.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Replace the Lamp on page
Remove the Exhaust Panel Skin on page
Section 3: Parts and Module Replacement
3-10.
A
3-9.
3-35