Configuring For Esci Mode; Optimizing The Esi Probe For Esci Operation; Installing The Corona Pin In The Source; Removing The Corona Pin From The Source - Waters SYNAPT G2 Operator's, Overview And Maintenance Manual

Configuring for ESCi mode

To operate in ESCi mode, you must fit the ESI probe and corona pin to the
LockSpray source enclosure.
The system, with the ESI probe installed and corona discharge pin fitted, can
alternate between ESI and ESCi modes, facilitating data acquisition in ESI
and ESCi modes in parallel. For more information on using dual ESI and
ESCi modes, see the SYNAPT G2 MS system online Help. When fitting the
ESI probe to the LockSpray source enclosure, follow the procedure on
page 3-2.

Optimizing the ESI probe for ESCi operation

See the mass spectrometer's online Help for details on how to optimize the ESI
probe for ESCi operation.

Installing the corona pin in the source

Install the corona pin according to the procedure on

Removing the corona pin from the source

Remove the corona pin according to the procedure on
page 5-12.
page 5-14.
Configuring for ESCi mode 3-19