Configuring The Magnet And Mikes And Nmrs Options; Viewing The Status Of, And Rebooting, The Instrument's Embedded Pc; Selecting The Instrument Name - Waters Autospec Premier Operator's Manual

Configuring the magnet and MIKES and NMRS options

Caution:
Settings dialog box until after consulting Waters, see
information" on page
To configure the magnet characteristics, and enable/disable the MIKES or
NMRS options (if fitted) click Options > Configuration.
Viewing the status of, and rebooting, the instrument's embedded
PC
To view the current status of the instrument's embedded PC
Click Options > Communications Status.
To reboot the instrument's embedded PC
1. Click Options > Communications Status.
2. In the System Manager dialog box, click Reboot.
Alternative:
use this method if problems are not cleared by rebooting from the
System Manager dialog box.

Selecting the instrument name

To select the instrument name
1. Click Options > Instrument Name.
2. Specify the required name in the ID text box.
3. Click OK.
You can add the instrument name to certain printouts, allowing
Tip:
identification if you are using a communal printer.
D-28 The MassLynx Tune window
Do not change the settings in AutoSpec Configuration
i-iv.
Reboot the EPC manually, using the EPC's power switch;
"Waters contact