Appendix D Headset Operation; Attaching The Headset; Terminal Operation Using The Headset - NEC UNIVERGE SV9500 User Manual

APPENDIX D

ATTACHING THE HEADSET

Connect the headset to HEADSET connector on the
back of the telephone following the procedure below.
The headset which can be connected to the telephone
Note
is "HW251N-A10 (manufactured by Plantronics)".
• TO CONNECT THE HEADSET
STEP 1: Insert the modular plug into the HEADSET
connector on the back of the telephone until it
clicks.
STEP 2: Place the headset cord into the groove as
shown in the figure below, and fix it.
Telephone
Modular Plug
Code
HEADSET OPERATION
HEADSET Connector
Groove
TERMINAL OPERATION USING THE
HEADSET
The following procedure explains how to operate a ter-
minal using the headset. While using the headset, the
operations equivalent to answering and ending a
phone call are available by pressing the Headset key.
Headset key must be programmed in advance. For the
Note
programming of Headset key, contact the system
administrator.
To Originate a Call
STEP 1: Press the Headset key, and the Headset key
lights red.
STEP 2: Line key lights green and dial tone is re-
ceived.
STEP 3: Dial a desired telephone number, after the
target party answers the call, you can start a
conversation.
STEP 4: Press Headset key to end the call, and the
Headset key turns off.
To switch to handset mode, lift the handset and press
Note
Headset key during a conversation.
241