Chapter 2 Panel Operator; Overview; Names And Functions; Display Selection - YASKAWA Sigma-V Series User Manual

2 Panel Operator

2.1.1 Names and Functions

2.1

Overview

2.1.1

Names and Functions

Panel operator consists of display part and keys.
Setting parameters, displaying status, executing utility functions, and monitoring SERVOPACK or converter
operation are possible with the panel operator.
The names and functions of the keys on the panel operator are as follows.
Note: To reset the servo alarm, press the UP Key and the DOWN Key simultaneously. Be sure to remove the cause
Key No.
2.1.2

Display Selection

Press the MODE/SET Key to make a selection in the following order.
Return to
2-2
SERVOPACK
Display part
and then reset the alarm.
Key Name
• To select a display.
MODE/SET Key
• To set the set value.
UP Key To increase the set value.
DOWN Key To decrease the set value.
• To display the set value by pressing this key for one second.
DATA/SHIFT Key
• To move to the next digit on the left when flashing.
Power ON
Press
MODE/SET
Press
MODE/SET
Press
MODE/SET
Press
MODE/SET
Keys
for one second.
Press
DATA/
DATA/SHIFT
Press for one second.
DATA/
DATA/SHIFT
Press for one second.
DATA/
DATA/SHIFT
Function
(Refer to 2.1.3.)
Status Display (Refer to 2.3)
Fn : Utility Function
(Refer to 2.2.)
(Refer to 2.4)
Pn : Parameter Setting
(Refer to 2.3.)
(Refer to 2.6)
Un : Monitor Display
(Refer to 2.4.)
(Refer to 2.7)
Analog