Interpreting Output Signal Display Status; Output Signal Display Example - YASKAWA Sigma-V Series User Manual

8 Monitor Displays (Un

8.5.2 Interpreting Output Signal Display Status

8.5.2

Interpreting Output Signal Display Status

The status of allocated signals is displayed on the 7-segment display on the panel operator.
Output terminals correspond to LED numbers as shown in the following table.
8 7
• When the output signal is in OFF status, the top segment (LED) is lit.
• When the output signal is in ON status, the bottom segment (LED) is lit.
Display LED
Note: Output signals use the following circuit configuration.
• OFF: Transistor OFF
• ON: Transistor ON
Example
ON: Transistor ON
8.5.3

Output Signal Display Example

Output signals are displayed as shown below.
• When the ALM signal is OFF
8 7 6
8-8
)
Analog
Top: OFF
Bottom: ON
6 5 4 3 2 1 Number
Output Terminal Name
Number
1 CN1-31, -32
2
CN1-25, -26
3 CN1-27,
4 CN1-29, -30
5
6
7
8
The top segment of
number 1 is lit.
5 4 3 2 1
/COIN or /V-CMP
-
28
CN1-37
CN1-38
CN1-39
−
Analog
Signal Name
(Factory Setting)
ALM
/TGON
/S-RDY
ALO1
ALO2
ALO3
Reserved