Software Version Display (Fn012) - YASKAWA Sigma-V Series User Manual

7.14 Software Version Display (Fn012)

Select Fn012 to check the SERVOPACK and encoder software version numbers.
(1) Preparation
There are no tasks that must be performed before the execution.
(2) Operating Procedure
Use the following procedure.
Display after
Step
Operation
1
2
3
4
5
Keys
Press the MODE/SET Key to select the utility function.
MODE/SET DATA/
Press the UP or DOWN Key to select Fn012.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one second
to display the SERVOPACK software version number.
MODE/SET DATA/
Press the MODE/SET Key to display the encoder software
version number.
Note: If the MODE/SET Key is pressed again, a pre-pro-
grammed display will appear. The display will
MODE/SET DATA/
change as follows: 0.0000 → S.FFFF → F.FFFF.
Press the DATA/SHIFT Key for approximately one second.
"Fn012" is displayed again.
MODE/SET DATA/

7.14 Software Version Display (Fn012)

Operation
7
7-25