Warning Output Signal (/Warn) - YASKAWA Sigma-V Series User Manual

Resetting Alarms by Turning ON the /ALM-RST Signal
Type Signal Name
Input /ALM-RST
Resetting Alarms Using the Panel Operator
Simultaneously press the UP and the DOWN Keys on the panel operator. For details, refer to 2.1.1 Names and
Functions.
Resetting Alarms Using the Digital Operator
Press the ALARM RESET Key on the digital operator. For details, refer to
tion of Digital Operator (No.: SIEP S800000 55).

5.10.2 Warning Output Signal (/WARN)

This signal is for a warning issued before the occurrence of an alarm.
Refer to 10.2.1 List of Warnings.
(1) Signal Specifications
Signal
Type
Name
Output /WARN
Note: Use parameter Pn50F.3 to allocate the /WARN signal for use. For details, refer to
tions
.
(2) Related Parameters
Set the output method for alarm codes in Pn001.3.
For details on alarm codes, refer to (2) Alarm Code Output Signals (ALO1, ALO2, and ALO3) of 5.10.1 Servo
Alarm Output Signal (ALM) and Alarm Code Output Signals (ALO1, ALO2, and ALO3).
Parameter
n.0
Pn001
n.1
For details on warning codes, refer to 10.2.1 List of Warnings.
Connector Pin
Number
CN1-44
Connector Pin
Setting
Number
ON (closed)
Must be allocated
OFF (open)
Meaning
Outputs alarm codes alone for alarm codes ALO1,
ALO2, and ALO3.
Outputs both alarm and warning codes for alarm codes
ALO1, ALO2, and ALO3, and outputs an alarm code
when an alarm occurs.
Meaning
Alarm reset
Σ
-V Series User's Manual, Opera-
Warning status
Normal status
When Enabled Classification
5.10 Other Output Signals
Meaning
3.4.2 Output Signal Alloca-
After restart Setup
5
5-79