YASKAWA Sigma-V Series User Manual page 52

3 Wiring and Connection
3.1.1 Main Circuit Terminals
Converter
CN101
CN103,
CN104
1,
L1, L2, L3
Terminals
L1, L2, L3
CN101
P, N
B1, B2
1,
CN103,
CN104
3-4
Converter
SGDV-COA2BAA
SGDV-COA3ZDA
2
Name
Main circuit power input terminals
Control power input connector
Main circuit DC voltage output ter-
minals
Ground terminal
Regenerative resistor connection
terminals
DC reactor connection terminals
2
Control power output connectors
CN101
CN103,
CN104
1, 2
P, N
B1, B2
B1, B2
L1, L2, L3
SGDV-COA AA: Three-phase, 200 to 230 VAC, +10% to -
15%, 50/60 Hz
SGDV-COA DA: Three-phase, 380 to 480 VAC, +10% to -
15%, 50/60 Hz
SGDV-COA AA: Single-phase, 200 to 230 VAC, +10% to -
15%, 50/60 Hz
DA: 24 VDC, ±15%
SGDV-COA
Mating connector model: 231-202/026-000 (Manufactured by
Connect these terminals to the P and N terminals on the SERVO-
PACK.
Connect this terminal to the power supply ground terminal and
then ground it.
Connect these terminals to the regenerative resistor unit.
Remove the short bar before you connect a DC reactor.
CN103 and CN104 output 24 VDC to the SERVOPACK.
For a 400-V system, the 24-VDC (±15%) input is output unaltered
from CN103. CN104 provides the same output, but it is normally
not necessary to connect it.
Converter
SGDV-COA3GAA
SGDV-COA5EDA
Specifications
Wago Company of Japan, Ltd)
Pin 2: 24 V
Pin 1: 0 V
P, N