At&D Set Dtr Function Mode; At&E Set Connect Result Code Format About Speed - SimCom SIM7000 Series At Command Manual

Time
Reference Note
V.25ter
2.2.22 AT&D Set DTR Function Mode
AT&D Set DTR Function Mode
Execution Response
Command This parameter determines how the TA responds when circuit 108/2 (DTR)
AT&D[<value>] is changed from the ON to the OFF condition during data mode.
OK
or
ERROR
Parameters
<value>
Parameter Saving -
Mode
Max Response -
Time
Reference Note
V.25ter
2.2.23 AT&E Set CONNECT Result Code Format About Speed
AT&E Set CONNECT Result Code Format About Speed
Execution This parameter setting determines to report Serial connection rate or
Command Wireless connection speed. It is valid only ATX above 0.
AT&E[<value>] Response
OK
or
ERROR
Parameters
<value>
Parameter Saving NO_SAVE
Mode
Max Response -
Time
SIM7000 Series_AT Command Manual_V1.03
0 TA ignores status on DTR.
1 ON->OFF on DTR: Change to Command mode with
remaining the connected call.
2 ON->OFF on DTR: Disconnect call, change to Command
mode. During state DTR = OFF is auto-answer off.
0 Wireless connection speed in integer format.
1 Serial connection rate in integer format. Such as: "115200"
30
Smart Machine Smart Decision
2018-05-08