At+Cipsprt Set Prompt Of '>' When Module Sends Data; At+Cipserver Configure Module As Server - SimCom SIM7000 Series At Command Manual

8.2.18 AT+CIPSPRT Set Prompt of '>' When Module Sends Data
AT+CIPSPRT Set Prompt of '>' When Module Sends Data
Test Command Response
AT+CIPSPRT=? +CIPSPRT: (list of supported <send prompt>s)
OK
Parameters
See Write Command
Read Command Response
AT+CIPSPRT? +CIPSPRT: <send prompt>
OK
Parameters
See Write Command
Write Command Response
AT+CIPSPRT=< OK
send prompt> ERROR
Parameters
<send prompt> A numeric parameter which indicates whether to echo
prompt '>' after module issues AT+CIPSEND command.
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note

8.2.19 AT+CIPSERVER Configure Module as Server

AT+CIPSERVER Configure Module as Server
Test Command Response
AT+CIPSERVE +CIPSERVER: (0-CLOSE SERVER, 1-OPEN SERVER),(1-65535)
R=?
OK
Parameters
See Write Command
SIM7000 Series_AT Command Manual_V1.03
0 It shows "send ok" but does not prompt echo '>' when sending
is successful.
1 It prompts echo '>' and shows "send ok" when sending is
successful.
2 It neither prompts echo '>' nor shows "send ok" when sending is
successful.
Smart Machine Smart Decision
138 2018-05-08