At+Ftpetget Download File - SimCom SIM7000 Series At Command Manual

OK
+FTPETPUT: 1,<error>
If mode is 2:
+FTPETPUT: 2,1
...
<ETX>
OK
If data transfer finished:
+FTPETPUT: 1,0
If data transfer failed:
+FTPETPUT: 1,<error>
Parameters
<mode>
<error>
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note


11.2.25 AT+FTPETGET Download File

AT+FTPETGET Download File
Test Command Response
AT+FTPETGET
=? OK
Parameters
See Write Command
Write Command Response
AT+FTPETGET If mode is 1 and successfully open GET session:
=<mode> OK
+FTPETGET: 1,1
SIM7000 Series_AT Command Manual_V1.03
//Input data
//To notify the module that all data has been sent, switch
from data mode to command mode
1 For opening FTPETPUT session.
2 For writing FTP upload data.
See "AT+FTPEXTGET"
The TCP/IP stack will only interpret an <ETX> character as the end of
the file to be transferred if it's not preceded by a <DLE> character. As a
consequence the attached host must send <ETX> characters preceded
by <DLE> characters and it must also code <DLE> characters in
<DLE><DLE>.
Smart Machine Smart Decision
185 2018-05-08