At+Cipcsgp Set Gprs For Connection Mode - SimCom SIM7000 Series At Command Manual

Read Command Response
AT+CIPSERVE +CIPSERVER: <mode>[,<port>,<channel id>,<bearer>]
R?
OK
Parameters
See Write Command
Write Command Response
AT+CIPSERVE OK
R=<mode>[,<por ERROR
t>]
Parameters
<mode>
<port>
<channel id> Channel id
<bearer>
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note
This command is allowed to establish a TCP server only when the state is IP
INITIAL or IP STATUS when it is in single state. In multi-IP state, the state
is in IP STATUS only.

8.2.20 AT+CIPCSGP Set GPRS for Connection Mode

AT+CIPCSGP Set GPRS for Connection Mode
Test Command Response
AT+CIPCSGP=? +CIPCSGP: 1-GPRS,APN,USER NAME,PASSWORD
OK
Parameters
See Write Command
Read Command Response
AT+CIPCSGP? +CIPCSGP: <mode>,<apn>,<user name>,<password>[,<rate>]
OK
Parameters
See Write Command
Write Command Response
AT+CIPCSGP=< OK
mode>[,(<apn>,< ERROR
SIM7000 Series_AT Command Manual_V1.03
0 Close server
1 Open server
1..65535 Listening port
GPRS bearer
139
Smart Machine Smart Decision
2018-05-08