At+Cipshowtp Display Transfer Protocol In Ip Head When Received Data - SimCom SIM7000 Series At Command Manual

OK
Parameters
See Write Command
Write Command Response
AT+CIPCCFG= OK
<NmRetry>,<Wa ERROR
itTm>,<SendSz>,
Parameters
<esc>[,<Rxmode
<NmRetry>
>,<RxSize>,<Rxt
value is 5.
imer>]
<WaitTm>
sending the packet. Default value is 2.
<SendSz>
before sending. Default value is 1024.
<esc>
<Rxmode>
port.
<RxSize>
<Rxtimer>
again. Default value: 50ms
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note
This command will be effective only in single connection mode
(+CIPMUX=0)

8.2.25 AT+CIPSHOWTP Display Transfer Protocol in IP Head When Received Data

AT+CIPSHOWTP Display Transfer Protocol in IP Head When Received Data
Test Command Response
AT+CIPSHOWTP +CIPSHOWTP: (list of supported <mode>s)
=?
OK
Parameters
See Write Command
Read Command Response
AT+CIPSHOWTP +CIPSHOWTP: <mode>
SIM7000 Series_AT Command Manual_V1.03
Number of retries to be made for an IP packet.Default
Number of 100ms intervals to wait for serial input before
Size in bytes of data block to be received from serial port
Whether turn on the escape sequence, default is TRUE.
0 Turn off the escape sequence
1 Turn on the escape sequence
Whether to set time interval during output data from serial
0 output data to serial port without interval
1 output data to serial port within <Rxtimer> interval.
Output data length for each time. Default value is 1460.
Time interval (ms) to wait for serial port to output data
143
Smart Machine Smart Decision
2018-05-08