At+Cipctl Set The Mode When Receiving An Ip Packet - SimCom SIM7000 Series At Command Manual

Parameters
<IPaddr>
<retryNum>
<dataLen>
<timeout>
<ttl>
<replyId>
<IP Address>
<replyTime>
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note





10.2.2 AT+CIPCTL Set the Mode When Receiving an IP Packet

AT+CIPCTL Set the Mode When Receiving an IP Packet
Test Command
AT+CIPCTL=?
SIM7000 Series_AT Command Manual_V1.03
Address of the remote host, string type. This
parameter can be either:
- IP address in the format: "xxx.xxx.xxx.xxx"
- Host name solved by a DNS query
The number of Ping Echo Requset to send
1-100 Default: 4
The length of Ping Echo Request data
0-1024 Default: 8
The timeout, in units of 100 ms, waiting for a single
Echo Reply
1-600 Default: 100(10 seconds)
Time t o l i ve
1-255 Default: 64
Echo Reply number
IP Address of the remote host
Time, in ms, required to receive the
response
Before sending PING Request the GPRS context must be activated.
When the Echo Request timeout expires (no reply received on time),
the response will contains <replyTime> setting to 600 and <ttl>
setting to 255.
When executing this command, if PDP context is deactivated for
some reasons, such as out of service, etc.the "+PDP: DEACT" URC
is reported and the command will end immediately.
If executing the command in NB-IOT network,please config
<timeout> to 300(30 second).For example:
AT+CIPPING="www.google.cn",4,8,300,64
Response
+CIPCTL: (list of supported <mode>s)
OK
Parameters
See Write Command
Smart Machine Smart Decision
163 2018-05-08