At+Cipats Set Auto Sending Timer - SimCom SIM7000 Series At Command Manual

1) For single IP connection (+CIPMUX=0)
+IPD,<data length>:
2) For multi IP connection (+CIPMUX=1)
+RECEIVE,<n>,<data length>:
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note

8.2.17 AT+CIPATS Set Auto Sending Timer

AT+CIPATS Set Auto Sending Timer
Test Command Response
AT+CIPATS=? +CIPATS: (list of supported <mode>s),(list of supported <time>)
OK
Parameters
See Write Command
Read Command Response
AT+CIPATS? +CIPATS: <mode>,<time>
OK
Parameters
See Write Command
Write Command Response
AT+CIPATS=<m OK
ode>[,<time>] ERROR
Parameters
<mode>
module is sending data
<time>
after which the data will be sent
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note
SIM7000 Series_AT Command Manual_V1.03
A numeric parameter which indicates whether set timer when
0 Not set timer when module is sending data
1 Set timer when module is sending data
1..100 A numeric parameter which indicates the seconds
137
Smart Machine Smart Decision
2018-05-08