At+Ceng Switch On Or Off Engineering Mode - SimCom SIM7000 Series At Command Manual

5.2.35 AT+CENG Switch on or off Engineering Mode

AT+CENG Switch on or off Engineering Mode
Test Command Response
AT+CENG=? TA returns the list of supported modes.
+CENG: (list of supported <mode>s),(list of supported <Ncell>s)
OK
Parameters
See Write Command
Read Command Response
AT+CENG? Engineering Mode is designed to allow a field engineer to view and test the
network information received by a handset, when the handset is either in
idle mode or dedicated mode (that is: with a call active). In each mode, the
engineer is able to view network interaction for the "serving cell" (the cell
the handset is currently registered with) or for the neighboring cells.
TA returns the current engineering mode. The network information
including serving cell and neighboring cells are returned. <cell> carry with
them corresponding network interaction.
If camping on a gsm cell:
+CENG: <mode>,<Ncell>,<cell num>,<System Mode>
[+CENG: <cell>,"<bcch>,<rxl>,<bsic>,<cellid>
<CR><LF>+CENG:<cell>,"<bcch>,<rxl>,<bsic>,<cellid>,<mcc>,<mnc
>,<lac>"...]
OK
If camping on a CAT-M or NB-IOT cell:
+CENG: <mode>,<Ncell>,<cell num>,<System Mode>
[+CENG:
<cell>,"<earfcn>,<pci>,<rsrp>,<rssi>,<rsrq>,<sinr>,<tac>,<cellid>,<m
cc>,<mnc>,<tx power>"
<CR><LF>+CENG:<cell>,"<earfcn>,<pci>,<rsrp>,<rssi>,<rsrq>,<sinr
>"...]
OK
Parameters
See Write Command
Write Command Switch on or off engineering mode.
SIM7000 Series_AT Command Manual_V1.03
Smart Machine Smart Decision
,
<mcc>,<mnc>,<lac>"
109 2018-05-08