At+Cnbp Set The State Of The Band Preference - SimCom SIM7000 Series At Command Manual

Parameter
See Write Command
Write Command Response
AT+CBAND=<o OK
p_band> If error is related to ME functionality:
+CME ERROR: <err>
Parameter
<op_band>
marks.
Parameter Saving AUTO_SAVE
Mode
Max Response -
Time
Reference Note


5.2.6 AT+CNBP Set t h e state of the band preference

AT+CNBP Set the state of the band preference

Read Command Response
AT+CNBP? +CNBP: <mode>[,<lte_mode>]
OK
Parameter
See Write Command
Write Command Response
AT+CNBP=<mo OK
de>[,<lte_mode> ERROR
]
Parameter
<mode>
<pos>
0xFFFFFFFF7FFFFFFF
7
8
9
SIM7000 Series_AT Command Manual_V1.03
A string parameter which indicate the operation band.
And the following strings should be included in quotation
EGSM_MODE
DCS_MODE
ALL_MODE
Radio settings are stored in non-volatile memory.
Only for GSM
64bit number, the value is "1" << "<pos>", then or by bit.
Some special mode value declared below:
0x40000000 BAND_PREF_NO_CHANGE
Any (any value)
GSM_DCS_1800
GSM_EGSM_900
GSM_PGSM_900
Smart Machine Smart Decision
85 2018-05-08