At+Cipsrip Show Remote Ip Address And Port When Received Data - SimCom SIM7000 Series At Command Manual

user name>, Parameters
<password>)] <mode>
mode
<apn>
<user name> A string parameter which indicates the user name
<password> A string parameter which indicates the password
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note

8.2.21 AT+CIPSRIP Show Remote IP Address and Port When Received Data

AT+CIPSRIP Show Remote IP Address and Port When Received Data
Test Command Response
AT+CIPSRIP=? +CIPSRIP: (list of supported <mode>s)
OK
Parameters
See Write Command
Read Command Response
+CIPSRIP: <mode>
AT+CIPSRIP?
OK
Parameters
See Write Command
Write Command Response
AT+CIPSRIP=< OK
mode> ERROR
Parameters
<mode>
1) For single IP connection (+CIPMUX=0)
RECV FROM:<IP ADDRESS>:<PORT>
1) For multi IP connection (+CIPMUX=1)
+RECEIVE,<n>,<data length>,<IP ADDRESS>:<PORT>
Parameter Saving NO_SAVE
Mode
SIM7000 Series_AT Command Manual_V1.03
A numeric parameter which indicates the wireless connection
1 set GPRS as wireless connection mode
A string parameter which indicates the access point name
A numeric parameter which shows remote IP address and port.
0 Do not show the prompt
1 Show the prompt, the format is as follows:
140
Smart Machine Smart Decision
2018-05-08