At+Cipflt Set The Rules Of Ip Filter - SimCom SIM7000 Series At Command Manual

Read Command
AT+CIPCTL?
Write Command
AT+CIPCTL=<mod
e>
Parameter Saving
Mode
Max Response Time
Reference

10.2.3 AT+CIPFLT Set the Rules of IP Filter

AT+CIPFLT Set the Rules of IP Filter
Test Command
AT+CIPFLT=?
Read Command
AT+CIPFLT?
SIM7000 Series_AT Command Manual_V1.03
Response
+CIPCTL: <mode>
OK
Parameters
See Write Command
Response
OK
or
ERROR
or
+CME ERROR: <err>
Parameters
<mode> 0 Disable to send Echo Reply
1 Enable to send Echo Reply to every IP address
pinging it
2 Enable to send Echo Reply only to a subset of IP
Addresses pinging it. This subset of IP Addresses
can be set by "AT+CIPFLT" command.
NO_SAVE
-
Note
The value of <mode> is stored in non volatile memory.
Response
+CIPFLT: (list of supported <action>s),(list of supported <item>s)
OK
Parameter
See Write Command
Response
+CIPFLT: <item>,<ipAddr>,<mask>
[<CR><LF>+CIPFLT: <item>,<ipAddr>,<mask>
[...]]
OK
Parameter
See Write Command
Smart Machine Smart Decision
164 2018-05-08