At+Cnds Configure Service Domain Preference For Nb-Iot - SimCom SIM7000 Series At Command Manual

Parameter Saving AUTO_SAVE_REBOOT
Mode
Max Response -
Time
Reference Note


5.2.34 AT+CNDS Configure Service Domain Preference For NB-IOT

AT+CNDS Configure Service Domain Preference For NB-IOT
Test Command Response
AT+CNDS=? +CNDS: (list of supported <domain>s)
OK
Parameters
See Write Command
Read Command Response
AT+CNDS? +CNDS: <domain>
OK
Parameters
See Write Command
Write Command Response
AT+CNDS=<do OK
main> If failed:
+CME ERROR: <err>
Parameters
<domain>
Parameter Saving AUTO_SAVE_REBOOT
Mode
Max Response -
Time
Reference Note

SIM7000 Series_AT Command Manual_V1.03
4 Reserved
5 UE tries SNR level 2 band scan only
The command controls the band scan for different SNR levels. This
optimization is applicable only for NB-IOT and it reduces the band
scan time and power consumption.
1 PS(Packet Switched Domain) ONLY
2 CS(Circuit Switched Domain) + PS(Packet Switched Domain)
The command of AT+CSDP is used to config service domain
preference for GSM and CAT-M.If you want to config service domain
preference for NB-IOT,you can use AT+CNDS.
Smart Machine Smart Decision
108 2018-05-08