At+Cgnsurc Gnss Navigation Urc Report - SimCom SIM7000 Series At Command Manual

15.2.3 AT+CGNSURC GNSS Navigation URC Report

AT+CGNSURC GNSS Navigation URC Report
Test Command Response
AT+CGNSURC +CGNSURC: (0-255)
=?
OK
Parameters
See Write Command
Read Command Response
AT+CGNSURC TA returns the current URC setting
? +CGNSURC: <Navigation mode>
OK
Parameters
See Write Command
Unsolicited Result Code
+UGNSINF: <GNSS run status>,<Fix status>,<UTC date & Time>,
<Latitude>,<Longitude>,<MSL Altitude>,<Speed Over Ground>,
<Course Over Ground>,<Fix Mode>,<Reserved1>,<HDOP>,
<PDOP>,<VDOP>,<Reserved2>,<Satellites in View>,
<Satellites Used>,<Reserved3>,<C/N0 max>,<HPA>,<VPA>
Write Command Response
AT+CGNSURC OK
=<Navigation or
mode> ERROR
Parameters
<Navigation mode>:
Parameter Saving NO_SAVE
Mode
Max Response -
Time
Reference Note


SIM7000 Series_AT Command Manual_V1.03
0 Turn off navigation data URC report
1 Turn on navigation data URC report, and report every GNSS FIX
2 Turn on navigation data URC report, and report every 2 GNSS FIX
...
255 Turn on navigation data URC report, and report every 255 GNSS
FIX
Factory setting is "AT+CGNSURC=0".
URC "+UGNSINF: "parameters are the same as "+CGNSINF:"
return.
Smart Machine Smart Decision
208 2018-05-08