SimCom SIM7000 Series At Command Manual page 248

zone>",<dst>
+CTZV: "<time zone>"
DST: <dst>
+CPIN: <code>
+CPIN: NOT READY
+CPIN: NOT INSERTED
+CUSD:
<n>[,<str_urc>[,<dcs>]]
NORMAL POWER DOWN
UNDER-VOLTAGE
POWER DOWN
UNDER-VOLTAGE
WARNNING
OVER-VOLTAGE POWER
DOWN
OVER-VOLTAGE
WARNNING
RDY
+CFUN: <fun>
[<n>,]CONNECT OK
CONNECT
[<n>,]CONNECT FAIL
[<n>,]ALREADY
CONNECT
[<n>,]SEND OK
[<n>,]CLOSED
RECV FROM: <IP
ADDRESS>: <PORT>
+IPD,<data
size>,<TCP/UDP>:<data>
+RECEIVE,<n>,<length>
REMOTE IP: <IP
ADDRESS>
SIM7000 Series_AT Command Manual_V1.03
Refresh network time zone by network.
Refresh Network Daylight Saving Time
by network.
Indicates whether some password is
required or not.
SIM Card is not ready.
SIM Card is not inserted.
Indicates an USSD response from the
network, or network initiated operation.
SIM7000 is powered down by the
PWRKEY pin or AT command
"AT+CPOWD=1".
Under-voltage automatic power down.
under-voltage warning
Over-voltage automatic power down.
over-voltage warning
Power on procedure is completed, and
the module is ready to operate at fixed
baud rate. (This URC does not appear
when auto-bauding function is active).
Phone functionality indication (This
URC does not appear when
auto-bauding function is active).
TCP/ UDP connection is successful
TCP/UDP connection in channel mode is
successful
TCP/UDP connection fails
TCP/UDP connection exists
Data sending is successful
TCP/UDP connection is closed
shows remote IP address and port
(only in single connection mode)
display transfer protocol in IP header to
received data or not (only in single
connection mode)
Received data from remote client (only
in multiple connection mode)
Remote client connected in
248
Smart Machine Smart Decision
AT+CPIN
AT+CUSD=1
AT+IPR=<rate>
<rate> is not 0
AT+IPR=<rate>
<rate> is not 0
AT+CIPSTART
AT+CIPSTART
AT+CIPSTART
AT+CIPSRIP=1
AT+CIPHEAD
AT+CIPSHOWTP
2018-05-08