At+Ftpetput Upload File - SimCom SIM7000 Series At Command Manual

If mode is 1 and failed to download data:
OK
+FTPEXTGET: 1,<error>
If mode is 3 and successfully download data:
+FTPEXTGET: 3,<length>
0123456...
OK
If <file name> is already exist in flash:
ERROR
Parameters
<mode>
<file name> File name length should less than or equal to 50 characters.
<pos>
<len>
<length> The length of the downloaded data from the remote machine.
<error>
Parameter Saving NO_SAVE
Mode
Max Response 75 seconds(In case no response is received from server)
Time
Reference Note


11.2.24 AT+FTPETPUT Upload File

AT+FTPETPUT Upload File
Test Command Response
AT+FTPETPUT
=? OK
Parameters
See Write Command
Write Command Response
AT+FTPETPUT If mode is 1 and successfully open PUT session:
=<mode> OK
+FTPETPUT: 1,1
If mode is 1 and failed to open PUT session:
SIM7000 Series_AT Command Manual_V1.03
0 use default FTPGET method.
1 open extend FTP get session and download data to RAM.
3 read the downloaded data from RAM, then output it to the
serial port.
data offset should less than <length>.
data length 0-300k.
See "AT+FTPGET"
The data it can get is 300k at most.
Smart Machine Smart Decision
184 2018-05-08