At+Ipr Set Te-Ta Fixed Local Rate - SimCom SIM7000 Series At Command Manual

Test Command Response
AT+IFC=? +IFC:
<dte_by_dce>s)
OK
Parameters
See Write Command
Read Command Response
AT+IFC? +IFC: <dce_by_dte>,<dte_by_dce>
OK
Parameters
See Write Command
Write Command Response
AT+IFC=<dce_b This parameter setting determines the data flow control on the serial
y_dte>[,<dte_by interface for data mode.
_dce>] OK
Parameters
<dce_by_dte>
data from TA
<dte_by_dce> Specifies the method will be used by TA at receive of data
from TE
Parameter Saving -
Mode
Max Response -
Time
Reference Note
V.25ter

2.2.32 AT+IPR Set TE-TA Fixed Local Rate

AT+IPR Set TE-TA Fixed Local Rate
Test Command Response
AT+IPR=? +IPR: (list of supported auto detectable <rate>s),(list of supported
fixed-only <rate>s)
SIM7000 Series_AT Command Manual_V1.03
(list of supported
Specifies the method will be used by TE at receive of
0 No flow contro
1 Software flow control
2 Hardware flow control
0 No flow control
1 Software flow control
2 Hardware flow control
35
Smart Machine Smart Decision
<dce_by_dte>s),(list
l
of supported
2018-05-08