Atz Reset Default Configuration; At&D Set Dtr Function Mode - SimCom SIM5300E At Command Manual

Reference V.25ter
2.2.16

ATZ Reset Default Configuration

ATZ Reset Default Configuration
Execution Command
ATZ[<value>]
Parameters
Reference V.25ter
2.2.17 AT&D Set DTR Function Mode
AT&D Set DTR Function Mode
Execution Command
AT&D[<value>]
Parameters
Reference V.25ter
SIM5300E AT Command Manual V1.02
detection are both enabled.
Response
TA sets all current parameters to the user defined profile.
OK
If error is related to ME functionality:
+CME ERROR: <err>
<value>
0 Restore profile 0
1 Restore profile 1
Note:
The command "ATZ" can set the default value of" AT&D"," ATE"," ATQ","
ATV"," ATX"," AT+CR"," AT+CRC".
Response
This parameter determines how the TA responds when circuit 108/2 (DTR) is
changed from the ON to the OFF condition during data mode.
OK
If error is related to ME functionality:
+CME ERROR: <err>
<value>
0 TA ignores status on DTR.
1 ON->OFF on DTR: Change to Command mode with remaining
the connected call.
2 ON->OFF on DTR: Disconnect call, change to Command mode.
During state DTR = OFF is auto-answer off.
15