SimCom SIM7000 Series At Command Manual page 99

<Operation Mode> UE operation mode.
<MCC>
<MNC>
<LAC>
<Cell ID>
<Absolute RF Ch Num>
<Track LO Adjust>
<C1>
<C2>
<TAC>
<SCellID>
<PCellID>
<Frequency Band>
<earfcn>
earching
<dlbw>
on the downlink
<ulbw>
<RSRP>
<RSRQ> Current reference signal receive quality as measured by L
<RSSI>
<RSSNR>
ng cell The value of SINR can be calculated according to <RSSNR>,
the formula is as below:
The range of SINR is from -20 to 30
Parameter Saving -
Mode
Max Response -
Time
Reference Note
SIM7000 Series_AT Command Manual_V1.03
"LTE NB-IOT"
"Online",
"Offline",
"Factory Test Mode",
"Reset",
"Low Power Mode".
Mobile Country Code (first part of the PLMN code)
Mobile Network Code (second part of the PLMN code)
Location Area Code (hexadecimal digits)
Service-cell Identify
Track LO Adjust
Coefficient for base station selection
Coefficient for Cell re-selection
Tracing Area Code
Serving Cell ID
Physical Cell ID
Frequency Band of active set
E-UTRA absolute radio frequency channel number for s
CAT-M or NB-IOT cells
Transmission bandwidth configuration of the serving cell
Transmission bandwidth configuration of the serving cel
l on the uplink
Current reference signal received power.Available for C
AT-M or NB-IOT.
1.
Current Received signal strength indicator
Average reference signal signal-to-noise ratio of the servi
SINR = 2 * <RSSNR> - 20
Smart Machine Smart Decision
AFRCN for service-cell.
99 2018-05-08