At+Cipflt Set The Rules Of Ip Filter - SimCom SIM5300E At Command Manual

Read Command
AT+CIPCTL?
Write Command
AT+CIPCTL=
<mode>
Parameters
Reference
8.2.3

AT+CIPFLT Set the Rules of IP Filter

AT+CIPFLT Set the Rules of IP Filter
Test Command
AT+CIPFLT=?
Read Command
AT+CIPFLT?
Write Command
AT+CIPFLT=
<action>[,<item>][,
<ipAddr>,<mask>]
Parameters
SIM5300E AT Command Manual V1.02
Response
+CIPCTL: <mode>
OK
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
<mode>
0 Disable to send Echo Reply
1 Enable to send Echo Reply to every IP address pinging it
2 Enable to send Echo Reply only to a subset of IP Addresses
pinging it. This subset of IP Addresses can be set by "AT+CIPFLT"
command.
Note:
The value of <mode> is stored in non volatile memory.
Response
+CIPFLT: (list of supported <action>s),(list of supported <item>s)
OK
Response
+CIPFLT: <item>,<ipAddr>,<mask>
[<CR><LF>+CIPFLT: <item>,<ipAddr>,<mask>
[...]]
OK
If error is related to ME functionality:
+CME ERROR: <err>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
<action>
0 Remove the rule specified by <item>. <item> must be
1 Add the rule specified by <item>.If <item> is not given,
find an empty item automatically. <ipAddr> and <mask> must be
given.
it can
178