Vacuum Pump - Suzuki Baleno Manual

1. ECT gauge (for combination meter)
2. ECT switch (for combination meter)
3. Water outlet box
ENGINE AND EMISSION CONTROL SYSTEM (XUD9BSD ENGINE) 6E3-11

VACUUM PUMP

REMOVAL
1) Disconnect hoses attached vacuum pump.
2) Remove vacuum pump from cylinder head.
INSTALLATION
1) Fit the dogs of vacuum pump coupling into the slot of camshaft.
NOTE:
Use new O-rings.
2) Install vacuum pump and tighten bolts and nut to specified
torque.
Tightening torque
1. Vacuum pump
2. O-ring
(a): 25 N·m (2.5 kg-m, 18.0 lb-ft)
3. Camshaft
ENGINE COOLANT TEMPERATURE SENSOR
(ECT SENSOR)
REMOVAL
1) Disconnect battery negative cable at battery.
2) Drain coolant referring to Section 6B.
WARNING:
To help avoid danger of being burned, do not remove
radiator cap while engine and radiator are still hot.
Scalding fluid and steam can be blown out under pres-
sure if cap is taken off too soon.
3) Disconnect connector from ECT sensor.
4) Remove ECT sensor (1) from water outlet box.