Suzuki Baleno Manual page 2135

PROCEDURE 020
No re-acceleration/no liveliness (with or without emission of smoke)
Perform DTC check using SUZUKI scan tool.
(Refer to "DIAGNOSTIC TROUBLE CODE (DTC) CHECK".)
If DTC(s) is indicated, go to applicable DTC.
Ensure theat the pump and the injectors are correct.
Is the diesel supply system correct?
(Refer to "Procedure 026"
in "All models diesel diagnosis manual".)
Is the accelerator cable adjusted correctly?
(Refer to "Injection pump settings:
BOSCH equipment (Non-industrial setting)"
in "Overhaul checking tuning manual".)
Is the pump static timing correct?
(Refer to "Fuel injection pump static timing
adjustment and checking" in section 6E3.)
Is the injector calibration pressure correct?
(Refer to "Injector inspection" in section 6E3.)
Are the valve clearances correct?
(Refer to "Valve clearance"
in section 6A4 of this manual.)
Are the compression values correct?
(Refer to "Compression check"
in section 6A4 of this manual.)
Remove the injection pump and have it checked by BOSCH dealer.
(Refer to "Fuel injection pump removal and installation" in section 6E3.)
NOTE: If the fault persists after checking the pump, check the conformity of the thickness of the cylinder
head gasket.
No
Yes
Yes
No
Yes
Yes
No
Yes
No
Yes
ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-81
Make the necessary repairs.
No
Adjust the accelerator cable.
Set the injection pump timing.
No
Adjust or replace the faulty injectors
(see the precautions to be taken).
Make the necessary repairs.
Special tool
(A): 09912-56510/
OUT0000077
(Pressure gauge)