Suzuki Baleno Manual page 2250

8G-4 IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED)
IGNITION KEY
The ignition key for the immobilizer control system has a built-in
transponder. Each transponder in the key has an each transmitting
code (Transponder code). The code will transmitted from the key
via the coil antenna to Immobilizer Control Module when the igni-
tion switch is turned ON.
1. Ignition key with built-in transponder
COIL ANTENNA
The coil antenna is installed to the steering lock assembly. As it is
energized by Immobilizer Control Module, it transmits the trans-
ponder code of the ignition key to Immobilizer Control Module.
1. Coil antenna
IMMOBILIZER CONTROL MODULE & FUEL INJEC-
TION PUMP
Immobilizer Control Module:
Immobilizer Control Module is installed to the underside of the
instrument panel at the driver's seat side.
As main functions, Immobilizer Control Module checks matching
not only between the Transponder Code transmitted from the igni-
tion key and that registered in Immobilizer Control Module (Up to
4 different Transponder codes can be registered.) but also be-
tween the ECU code transmitted from Fuel Injection Pump and that
registered in Immobilizer Control Module. In addition, it has an on-
board diagnostic system (self-diagnosis function) which is de-
scribed in the following page.
1. Immobilizer Control Module
Fuel Injection Pump:
As main functions, Fuel Injection Pump checks matching of ECU
codes.
For installation position of Fuel Injection Pump, refer to ENGINE
AND EMISSION CONTROL SYSTEM section of this manual.