Suzuki Baleno Manual page 2215

7A-6 MANUAL TRANSMISSION
Viscosity chart
SAE
ON-VEHICLE SERVICE
OIL CHANGE
1) Before changing or inspecting oil, be sure to stop engine and lift
2) With vehicle lifted up, check oil level and leakage.
3) Drain old oil and fill new specified oil by specified amount (up to
4) Torque drain and level/filler plugs as specified below. Apply
1. Drive shaft (LH)
2. Oil drain plug
3. Oil level/filler plug
vehicle horizontally.
If leakage exists, correct it.
level hole).
sealant to thread of drain plug before installation.
"A": Sealant 99000-31110
Tightening Torque
(a): 21 N·m (2.1 kg-m, 15.5 lb-ft)
NOTE:
D It is recommended to use API GL-4 75W-90 gear oil.
D Whenever vehicle is hoisted for any other service work
than oil change, also be sure to check for oil leakage.
Oil specification: API GL-4
For SAE classification, refer to viscosity
chart at the left.
Oil capacity: 2.2 liters (4.6/3.9 US/lmp. pt)